Foster F2000 86.2V.STD Manual download pdf (Page 3)

After having positioned the sink on the worktop, fix it by tightening the screws of

the brackets which are provided (the screws must be tightened just enough to have

the brackets clamp down on the worktop).

Afterwards, remove the excess gasket with a

cutter. The taps can be installed before or after

the positioning of the sink.

After having installed the sink, connect the

waste-fitting with the siphon. Check the water-

tightness by closing the basket of the waste-

fitting, open the tap and wait until the water

level reaches the overflow; shut the tap, and

wait several minutes, verifying that the water

does not drain away. Empty the sink.

Flush-mount edge

For a correct installation of the flush-mount sinks, please follow strictly the technical

sheet (template) provided with the sink; only qualified personnel should make the cut-

out, and a computer-operated machine is necessary. It is advisable to accurately clean

the seat for the cut-out, and to insert the gasket which is provided, between the sink and

the worktop, so as to avoid possible water infiltration into the worktop or the cabinets.

The work must be carried out by experienced personnel.

Do not use electric screwdrivers to tighten the brackets.

The tightening torque must not exceed 60 N/cm.

It is advisable to install the flush-mount sinks on hydro

repellent materials, in order to avoid eventual deformations

of the material itself.

1 2 3 4 5

No comments

Foster F2000 86.2V.STD Manual Page 3